Stream from Larix Broadcaster
Larix Broadcaster turns a phone into a portable encoder. Add an RTMP connection pointing at your Stream Repeater ingest URL and broadcast over mobile data or Wi-Fi.
New connection
Step-by-step setup
Follow these steps in Larix Broadcaster, then start one broadcast for every destination.
Open Connections
In Larix, tap the gear → Connections → New connection.
Enter the URL
Paste your RTMP server and stream path as the connection URL.
Set mode to Publish
Make sure the connection mode is Publish, not Play.
Add RTMP authentication
Enable RTMP authentication and enter your stream name as the login and key as the password.
Tap the record button
Save, return to the camera and tap the large button to go live.
Your ingest details
Use the values from your own stream page. These examples show where each value belongs.
Keep your stream key private. It authorises publishing to your stream.
Larix tips
A few practical details for a stable broadcast.
- On mobile data, cap the bitrate at about 3–4 Mbps for 720p.
- Larix also supports SRT and RTSP when you need lower latency or greater resilience.
- Lock the orientation before going live so the relayed video stays upright.
Recommended settings
A dependable starting point for most platforms and connections.
| Video codec | H.264 (x264 or hardware encoder) |
|---|---|
| Resolution | 1920×1080 (or 1280×720) |
| Frame rate | 30 or 60 fps |
| Video bitrate | 4,500–6,000 kbps |
| Keyframe interval | 2 seconds |
| Audio | AAC, 160 kbps, 44.1 kHz |
Other encoder guides
Using a different app? The connection details work the same way.
Ready to stream everywhere?
Connect Larix Broadcaster once and let Stream Repeater handle every destination.
Get started Read the documentation