1. Help Centre
  2. Streaming & recording

Encoder settings for clean recordings

Your stream can stay live while its recording restarts. When our recorder cannot follow the timing of the video it receives, it closes the file and starts a new one about two seconds later. The broadcast carries on, but the recording arrives in pieces with short gaps between them.

What you will see

  • In your recordings, one broadcast shows as one recording with its pieces listed underneath, and every gap marked.
  • After the stream ends we join the pieces into one file automatically. Nothing is re-encoded, so quality is unchanged. The gaps cannot be recovered: nothing was recorded during them.
  • While you are live, the stream page shows an Encoder issues banner if the recording keeps restarting.

These settings give our recorder the steadiest timing. They are a compatibility check, not a guarantee, and they do not mean your connection is at fault.

  1. Video codec: H.264. Audio codec: AAC.
  2. B-frames: 0 (off). In OBS: Settings → Output → Output Mode: Advanced → Streaming, then set B-frames to 0 (x264: add bframes=0 to x264 options).
  3. Keyframe interval: 2 seconds.
  4. Rate control: CBR (constant bitrate).
  5. Frame rate: fixed — for example 30 or 60. Avoid variable frame rate.
  6. Watch your encoder's dropped / skipped frames counters. An overloaded encoder produces irregular timing.

After changing settings, stop and start the broadcast, then make a short test recording.

The encoder check

When a broadcast starts we read its first few seconds — without decoding or changing anything — and show a checklist on the stream page: whether B-frames are on, how far apart keyframes are, whether the frame timing is steady, and which codecs you are sending. It is advice only; your stream is never blocked.

"Another encoder tried to publish to this stream"

Only one encoder can publish to a stream at a time. If a second one connects while the first is live — for example the browser studio and OBS on the same stream — the second is refused, and you see it in your alerts and on the stream page. The first encoder keeps the stream, so neither can knock the other off in a loop.

To switch, stop the encoder you are not using. Or choose Let the waiting encoder take over on the stream page: the current broadcast ends and the waiting encoder can connect. The phone app's Take over button does the same from the app.

Still restarting?

Contact support with the time shown in the banner. We can check the recorder, the timing it received and our server clock.

Was this helpful?

Back to Help Centre

Can’t find what you need?

Tell us what you were trying to do and we’ll help you get it working.

Contact support
14 days of Pro free, no card Start for free